Kitchen Knife Steels Ranked by Total Card Cut in One Study
Xu and colleagues tested six steels used for kitchen knives. They measured how much standardized card each specimen cut over repeated cycles, a measure called total card cut (TCC).
Six samples from the same test group
Figure 4a in the paper shows the following order for TCC in the 18° group, from highest to lowest.
- CPM 3V
- 9Cr18MoV
- GCr15
- 1.4116
- T10
- 3Cr13
Reading a kitchen knife specification
The result belongs to the experimental sample. A steel name on a retail knife tells you which material was used. To compare two finished chef’s knives, look for a measurement on each finished model under the same test. The chart gives no estimate of time between sharpenings in a home kitchen. Read Figure 4a in the original Metals paper, page 9 (PDF).